Resetting - GE L90 Instruction Manual

5 SETTINGS
!"
PATH: SETTINGS INPUTS/OUTPUTS

# RESETTING

#
Some events can be programmed to latch the faceplate LED event indicators and the target message on the display. Once
set, the latching mechanism will hold all of the latched indicators or messages in the set state after the initiating condition
has cleared until a RESET command is received to return these latches (not including FlexLogic™ latches) to the reset
state. The RESET command can be sent from the faceplate Reset button, a remote device via a communications channel,
or any programmed operand.
When the RESET command is received by the relay, two FlexLogic™ operands are created. These operands, which are
stored as events, reset the latches if the initiating condition has cleared. The three sources of RESET commands each cre-
ate the FlexLogic™ operand. Each individual source of a RESET command also creates its individual operand
RESET OP
,
RESET OP (PUSHBUTTON) RESET OP (COMMS)
shown above selects the operand that will create the
GE Multilin
!"
RESETTING
RESET OPERAND:
Off
or
RESET OP (OPERAND)
RESET OP (OPERAND)
L90 Line Differential Relay
5.7 INPUTS/OUTPUTS
Range: FlexLogic™ operand
to identify the source of the command. The setting
operand.
5.7.10 RESETTING
5
5-205