Set Repeat Printing - Hitachi IJ UX Instruction Manual

4.14.2 Set repeat printing

(1)Overview
●This is set to print the same print description continuously.
●Set the "Repeat intervals" and "Repeat count" for repeat printing.
●Repeat printing can not be used when setting "Auto" on "Product speed matching".
1
Repeat intervals
●The print target size can be specified.
●This setup is to be performed when the print target is transported while it is in close contact.
●After setting in character units or mm units, fine adjust in scan units.
●When you want to input in mm units, input "Line speed".
●Perform the following calculations for repeat intervals setup purposes.
(Example) Print target size: 64 mm; all-digit print width: 25 mm;
●Round off the calculation results to the nearest whole number.
Print target
Repeat count
2
●You can preset the number of repeats.
●If repeat printing is not needed, set the number to "0".
●Printing is performed in accordance with the repeat printing mode setup.
●The relationship between the repeat printing mode and the count is as stated below.
Signal ON
OFF - ON
transition
4-87 ●Set the print specifications
(i) On an individual scan basis
(1-digit character width × number of digits - trailing character correction value)
× (print target size/all-digit print width)
(ii) On an individual character basis
Number of digits × (print target size/all-digit print width)
●1-digit character width = (horizontal character size + inter-character space)
width increase setting
●Trailing character correction value = inter-character space
setting + 1
number of digits: 6; character size: 5 × 7 dots; inter-character space: 2 dots
●On an individual scan basis
((5+2)×1×6-(2×1+1))×(64/25)=99.84→100
●On an individual character basis
6×(64/25)=15.36→15
Repeat intervals
Mode
Printing is repeated a preselected
number of times at predefined
period intervals while the print target is
detected.
Printing is repeated a preselected
number of times at predefined
intervals once the print target is
detected.
Print target
Setting
2 to 9998
Repeat printing is performed
while the print target is detected.
Once the print target is detected,
repeat printing is performed until
it is aborted.
character
×
character width increase
×
9999