Setting High-Speed Printing - Hitachi IJ RX2 Technical Manual

Setting high-speed printing (Optional on RX2-S)
(1) Overview
● Three modes of HM, NM or QM can be selected.
By selecting the mode, high quality printing result can be ensured according to the line speed.
HM mode
Necessary conditions to perform high-speed print
1
● When all necessary conditions from Nos. 1 to 7 are satisfied, high-speed print HM, NM or QM
mode can be selected.
No.
1 Print line
2 Character size
3 Line spacing
4 Barcode
5 Character orientation 0 or 1.
6 Ink drop use rate
7 Ink drop charge rule
Print specifications
Message name [ ]
1st screen
Character
orientation
Printing method 2（１：Single scan ２：Interlaced ３：Mixed）
Print start
delay
Print start delay
NM mode
Item
Number of lines of all columns is the same.
(Refer to Table in " Type of high-speed print and number of
vertical dots used" for number of print lines available.)
Character size of all print items is the same.
(Refer to Table in " Type of high-speed print and number of
vertical dots used" for character sizes available.)
Line spacing of all columns is the same. However, if Line spacing is
set to 3 or more, High-speed printing is NOT available.
NOT available.
1/1
Standard (Single scan or interlaced)
[Stop ]
2nd screen 3rd screen
Character height
Ink drop use
HM
High-speed print
Character width ０００２
0:ＡＢＣ 1:ＡＢＣ 2: 3:
→ ← ←
Sensor Print start
００００
（0∼9999）SC
HM mode is equivalent to particle use
percentage of 1/1.
In the 2-line print setting, NM mode is
equivalent to ink drop use percentage
of 1/1.5.
If the line speed remains the same,
print width in the NM mode will widen
by 1.5 times with respect to HM mode.
Conditions
2
2
2015.07.07 12:45
Com=0
M
Manual
９０
（0∼99）
０１
（1/1∼1/16）
NM QM
（0∼3999）
Arrow : Prin-
→
ting direction
Edit
message
Print
format
Change unit
Back
●Setting high-speed print (Optional on RX2-S) 9-6
Remarks
Startup
HOME
High-speed print