Toshiba 1550 Service Manual page 67

<Notes>
1. When installing the clutch, align the end face of the clutch to the shaft groove and align the hexagonal
screw to the milling cutting surface. Insert the projection of the clutch and the gear arm in the hole of
the bracket.
2. Confirm that there is no oil, etc. on the surface of the paper feed roller or the separation pad.
3. When reassembling the timing belt (removed when taking cut the pick-up roller) pass it through the
upper side of the belt tensioner.
4. When installing the separation pad bracket to the copier, first free the paper stop lever by pushing
down the pick-up roller downwards.
1:
Note 1:
he projection into the
Put the projection into the
ket hole
bracket hole
Align with the groove
Align with the groove
Mar. 1998 © TOSHIBA 6 - 13
Note 1:
Note 1:
Put the
Put the projection
into the
into the bracket hole
<Illust
1550/1560 DRIVE