12.3 Disassembly and Replacement
12.3.1
Fuser unit
(1) Remove the left side cover (lower) (2 screws).
(2) Remove the inner cover (lower left) (1 screw).
(3) Remove one screw and disconnect three con-
nectors.
(4) Pull out the fuser unit toward the front.
Note: The screw holding the fuser unit is tightened
at the hole A at the time of shipping from the
factory.
However, when tilting the fuser unit in order
to correct the inclination of the straight im-
age, retighten the screw at the elongated
hole B.
12.3.2
Heater lamp
(1) Remove the fuser unit.
(2) Remove the fuser guard (1 screw).
(3) Remove the screw fastening the terminal on
the rear.
(4) Remove the lamp holder bracket (R) (1 screw).
Mar. 1998 © TOSHIBA
[Front side]
12 - 3
Fuser unit
Front side
Elongated hole B
Hole A
Fuser guard
Heater lamp
Lamp holder bracket R
Terminal fixing screw
1550/1560 FUSER