Toshiba 1550 Service Manual page 210

3. Fastening the MY-1004 and the copier
(1) Remove the cassettes from the copier and
the MY-1004, respectively.
(2) Using the fixing plate and screws (8, 9)
provided, fasten the copier and the MY-
1004 as shown in the Figure.
4. Installing the wire harness:
(1) Fit the wire harness on the rear of the MY-
1004 into the respective edge saddles of
the copier and the MY-1004 and connect
the harness to the J6 connector of the copi-
er's PC board.
1550/1560 UNPACKING PROCEDURE
9
One place at the front
8
Two places on the rear
8
One place on the feed side
18 - 14
8
Mar. 1998 © TOSHIBA