PRODUCT SETUP
5
User-programmable pushbuttons require a type HP or HQ faceplate. If an HP or HQ type faceplate was ordered
separately, the relay order code must be changed to indicate the correct faceplate option. This can be done in
NOTE
the EnerVista software with the Maintenance > Enable Pushbutton command.
5.3.13 Flex state parameters
SETTINGS PRODUCT SETUP FLEX STATE PARAMETERS
FLEX STATE
PARAMETERS
5-100
Figure 5-39: User-programmable pushbutton logic (Sheet 2 of 2)
PARAMETER 1:
Off
PARAMETER 256:
Off
Range: FlexLogic operand
Range: FlexLogic operand
D30 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS