Frequency Set By Keypad And Run/Stop By External Source - LG SV-iS5 Instruction Manual

4.3.2

Frequency set by Keypad and Run/Stop by External Source.

1. Connect wiring as shown below.
P1 P2 P3 FX RX NC
JOG CM
CM BX
2. Apply AC power.
3. Confirm that the DRV 03 is set at ' Fx/Rx-1' .
4. Confirm that the DRV 04 is set at
' Keypad-1' .
5. Press [SHIFT/ESC] key.
6. LCD: Press [PROG] key.
7-Seg: Press [PROG/ENT] key.
7. LCD: Set the frequency using [SHIFT/ESC]
and [? ] key.
7-Seg: Set the frequency by rotating the
encoder knob.
8. LCD: Press [ENT] key to save the data.
7-Seg: Press [PROG/ENT] key to save the
data.
9. Close the FX or RX contact to run the motor.
10. Open the FX or RX contact to stop the
motor.
Morek IT OÜ, Rauna 24, 76506 Saue Harjumaa, Estonia. www.morek.eu Tel. +372 604 1423 Fax +372 604 1447 morek@morek.eu
VR VI
RST
I FM 5G
DRV?T/K
00
DRV? Drive mode
03
DRV?
04
DRV?T/K
00
DRV? Cmd. freq
00
DRV? Cmd. freq
00
DRV?T/V
00
The FWD or REV LED starts blinking.
The FWD or REV LED starts blinking.
55
Chapter 4 – Quick start procedures
LCD Display
0.0 A
STP 0.00Hz
The DRV LED is ON.
Fx/Rx-1
Freq mode
Keypad-1
0.0 A
STP 0.00Hz
0.00Hz
The PROG/ENT LED is turned ON.
60.00Hz
The PROG/ENT LED is turned ON.
0.0 A
STP 60.00Hz
The RUN LED starts blinking.
The RUN LED starts blinking.
7-Segment Display