Appendix C. Changing Default Lan Ip Address; From The Status Page, Click On The Lan Settings Hyperlink Or From The Left-Hand Menu - LG LDK24 ADSL Router User Manual

click on Configuration>LAN connection. The LAN connections page is displayed.
Refer to the figure-usb1
e. Click on Create a new service. Click on the Ethernet bridged radio button, then click on
Configure. At the LAN connection: Ethernet bridged page, complete the following:
Description: eth1
Port: usb-ethernet
Click on Apply. The LAN connections page is displayed, containing details of the new
Ethernet transport. Refer to the figure-usb2.
f. From the left-hand menu, click on Configuration>Save config. At the Save
configuration page, click on Save.
g. The ethernet devices are attached to the bridge, and the bridge is attached to the router
by default via the iplan IP interface.
h. From here, you can configure the one WAN protocol of 3.3 Routed configurations you
want as well as PPPoE. The configuration of PPPoE in this section is similar to the
PPPoE routing setup in 3.3.4Ethernet –PPPoE routed. Refer to the 3.3 Routed
Configurations : 3.3.4 Ethernet -PPPoE routed about detailed configuration.

Appendix C. Changing default LAN IP address

By default, your ethernet device is already attached to the bridge using a default LAN
connection called iplan, IP address 192.168.1.1. if you want, you can change the default LAN IP
address to ipaddress you want to use.
You can change default LAN IP address by following instructions.
a. From the Status page, click on the LAN Settings hyperlink or from the left-hand menu,
click on Configuration>LAN connection. The LAN connections page is displayed. Refer
to the figure-usb1
b. Click on Change default LAN port IP address. In the Default LAN Port section, click on
the Primary IP Address text box and type ipaddress you want. Click on Apply.
LDK24 ADSL Router User's Manual
Version 1.0D
Copyright© 2002 LG Electronics Inc., LTD.
Page 60 of 67