that corresponds to the rfc1483-0 – external(for example) interface connection. The
page is refreshed and NAT is configured to translate addresses from the internal
security interface to the wan security interface.
3.5 Security configurations for Firewall
You can configure Firewall by using one of the following two ways :
• Configuring by Using default security level.
• Configuring by Using User Customization.
Now, in LDK24 system it is possible only to configuring firewall using default security level.
3.5.1 Starting security and enabling the firewall
To start security and enable the Firewall:
a. At the Security Interface Configuration page, click on the Security Enabled radio button.
Refer to the figure-22.
b. Click on Change State. The page is refreshed and Security is enabled.
Refer to the figure-23.
c. Click on the Firewall Enabled radio button. Click on Change State. The page is
refreshed and the Firewall is enabled.
LDK24 ADSL Router User's Manual
Version 1.0D
<figure -24>
Copyright© 2002 LG Electronics Inc., LTD.
Page 32 of 67