Snmp - Bosch DIVAR AN 3000 Operation Manual

58 en | Configuration
If uploading snapshot images to the FTP server (e.g. in an alarm situation), first input snapshot
mode, size, quality and frequency in the Encode screen (see Encode, page 40) so the system
can correctly upload the image files. The snapshot upload can be triggered in the following
menu settings:
–
–
–
6.6.10

SNMP

Figure 6.19: Network - SNMP
SNMP (Simple Network Management Protocol) provides the basic network management frame
of the network management system, and can be used to retrieve basic system health
information. It can also be used to configure the system to send out traps for events such as
system reboot, video loss, hard disk errors, etc.
The SNMP files can be retrieved/received on devices using common tools such as MG-SOFT
MIB Browser. The Management Information Base (MIB) can be downloaded via the Web Client
in menu Setup > Network > SNMP; press the button <Download MIB>.
Use the following steps to configure SNMP:
1.
2.
3.
4.
2015.10 | v2.3 | AM18-Q0669
Schedule
Detect (motion, camera masking, video loss)
Alarm
Select the 'SNMP enable' box.
Use the defaults for 'SNMP port', 'Read community', 'Write community', or assign your
settings if required.
To set up traps, press <Add> and enter IP addresses and ports of the devices that should
receive the trap notification. Press <Delete> to delete a device from the list.
Use the defaults or assign settings for 'Video loss' events sent to the trap:
– Single mode (set a time limit for detecting a single video loss to generate the trap)
Operations Manual
DIVAR AN 3000 / DIVAR AN 5000
Bosch Security Systems