Bosch CCS 1000 D Operation Manual page 48

48 en | Configuration
Recorder (CCSD‑CURD only)
Click the Recorder button to open the recorder settings page.
The following recorder settings are available:
–
–
–
Seats
Click the Seats button to open the seat settings page.
Here the seat settings for the Discussion Devices can be configured:
–
–
2016.05 | V2.0 |
Source: Select which audio source must be recorded:
– Floor only: The audio of the floor discussion language is recorded.
– Floor and output 3, 4, 5, 6: The audio of the floor discussion language and selected
audio output signal (3-6) are mixed and recorded.
Bit rate: Select the recording audio quality (from 64 kbps (lowest) up to 256 kbps
(highest)).
Automatically pause recording when all microphones are switched off: Recording is
paused when no microphone is active.
Seats overview:
– (x–y): x = number of Discussion Devices currently connected to the system and
initialized. y = historical number of Discussion Devices connected to the system.
Click one of the square icons on the left of this page to locate a Discussion Device in
the meeting room. When a tick is displayed in the checkbox, the light‑ring indicator
in the corresponding microphone is lit red and the LED indicator above the
microphone button flashes.
Note: This is only possible when the Selection mode checkbox at the left bottom of
the page is selected.
– Seat name: Click in the Seat name dialog box and enter/change the seat name as
required.
– Mode: The settings in the Mode column can be used to change the function of
individual seats/Discussion Devices. A Discussion Device can be configured as an
'interruption microphone' that can always get the floor regardless of the number of
open microphones. The 'interruption microphone' has the same rights as the
chairperson except for priority. The participant using the 'interruption microphone' is
not added to the request list. Typically an interruption microphone is positioned at a
podium for use by guest speakers. A total of 25 Discussion Devices can be
configured as a chairperson's device or interruption microphone. For example, 22
chairperson's devices + 3 interruption microphones = 25 devices in total.
Normal: The Discussion Device operates as a participant device.
Button: The Discussion Device operates as an interruption microphone. The speaker
has to push and release the button to enable the microphone and push and release
the button again to disable the microphone.
PTT (Push-to-talk): The Discussion Device operates as an interruption microphone.
The microphone is enabled for as long as the speaker pushes and holds in the
microphone request button.
Note: To use the interruption microphone setting, the slide switch at the base of the
discussion device must be set to participant. Refer to Configure Discussion Device,
page 36.
– Camera: The camera name connected to the seat.
– Pre-position: Camera preposition setting number assigned to the seat.
Selection mode (select on Discussion Devices): When selected, a Discussion Device can
be located by selecting the seat in the list or by pushing the Discussion Device
microphone request button. The Discussion Device LEDs are illuminated.
Operation manual
Digital Discussion System
Bosch Security Systems B.V.