Bosch CCS 1000 D Operation Manual page 46

46 en | Configuration
Audio
Click the Audio button to open the audio settings page:
–
–
–
–
–
–
–
–
Cameras
Click the Cameras button to open the camera settings page.
–
2016.05 | V2.0 |
– Configure: This right gives access to the system settings page (excluding the users
page, unless the user has the right 'modify users'), the system info and logging
pages, and volume control.
– Prepare system: This right gives access to the power page.
System:
– Master: Master volume to control the loudspeakers of the discussion devices and the
PA (audio output 1).
– LSP: Individual volume control for the loudspeakers of the discussion devices.
– PA: Individual volume control for the PA (audio output 1).
Line input/output: Sets the sensitivity of the analogue audio input and audio output
levels 1 and 2 of the Control Unit.
XLR Microphone: Defines the mode of audio input 1 of the Control Unit:
– When selected, it enables input 1 (XLR) for microphone signal level.
– When not selected, it enables input 1 (RCA socket) for audio line input level.
Routing options I/O 2: Defines the audio routing mode of input 2 and output 2 of the
Control Unit:
– Recorder: Use the recorder mode to connect an external recorder via audio input 2
and output 2.
– Floor: In floor mode, audio input 2 and output 2 are used, and the level is controlled
independently.
– Mix-minus: Use the Mix‑minus mode to connect two systems via audio input 2 and
audio output 2.
– Insertion: In the Insertion mode, audio output 2 and audio input 2 are both used to
add signals from external audio devices. For example, connection of an external
audio mixer between audio output 2 and audio input 2.
Line output: Sets the sensitivity of the analogue audio input and audio output levels 3, 4,
5, or 6 of the Control Unit.
Individual microphone output (CCSD‑CURD only): Select the routing of the analogue
audio outputs 3, 4, 5 or 6 of the Control Unit:
– Select 3, 4, 5 or 6 to enable selectable microphones for individual recording.
Digital Acoustic Feedback Suppression (DAFS): Settings for the DAFS function:
– Off: Sets the DAFS function to off.
– Natural: Sets the DAFS function to on.
– Maximum: Sets the system volume to a maximum with minimal risk of acoustic
feedback (howling) occurring.
Note: Audio artifacts might occur at higher volume levels.
Feedback prevention:
– Loudspeaker active when microphone is on: The participant's loudspeaker is active
when their microphone is on.
– Attenuate headphone when speaking: Attenuates the headphone volume of the
Discussion Devices with 18 dB when selected and the microphone is on.
Overview camera: Sets the camera used as the overview camera.
SDI Switcher: Enter the IP address of the HD‑SDI video switcher. Do not use leading
zeros. If leading zeros are entered, the CCS 1000 D Digital Discussion System will not be
able to control the switcher.
Operation manual
Digital Discussion System
Bosch Security Systems B.V.