Bosch CCS 1000 D Operation Manual page 25

Digital Discussion System
3.
4.
5.
6.
7.
Caution!
Non-approved power supplies can damage the equipment. Only use the original Bosch
!
supplied 24 VDC power supply.
Bosch Security Systems B.V.
If you want to use the web browser interface or system cameras with the CCS 1000 D
Digital Discussion System, connect an RJ45 Ethernet cable to the 'Network' connector at
the rear of the Control Unit.
Connect the other end of the Ethernet cable to an Ethernet switch, laptop, or PC.
Use RCA cables to connect audio equipment to the 'Audio In' and 'Audio Out' connectors
at the rear of the Control Unit, as required. Inputs and outputs are not galvanic
separated. If galvanic separation is required (e.g. to avoid hum), it must be provided
externally.
Connect the supplied 24 VDC power supply connector to the 'power' connector at the
rear of the Control Unit.
Connect the mains plug of the 24 VDC power supply to a mains supply. The system will
automatically switch on at the moment the mains supply is connected. This allows the
system to recover from a power failure.
Operation manual
Connections | en 25
2016.05 | V2.0 |