HP P2000 G3 MSA Reference Manual page 41

266
Info. A volume-copy operation for the indicated master volume has been aborted.
Recommended actions
• No action is required.
267
Error While cleaning up resources in metadata at the end of a background volume copy process, the firmware
found at least one error and suspended the process for the indicated volume.
Recommended actions
• Make sure that disks and vdisks associated with the volume copy do not have problems (health OK,
status FTOL or UP) and then retry the volume copy.
268
Info. A background volume-copy operation for the indicated master volume has completed.
Recommended actions
• No action is required.
269
Info. A partner firmware update operation has started. This operation is used to copy firmware from one
controller to the other to bring both controllers up to the same version of firmware.
Recommended actions
• No action is required.
270
Warning Either there was a problem reading or writing the persistent IP data from the FRU ID SEEPROM, or invalid
data were read from the FRU ID SEEPROM.
Recommended actions
• Check the IP settings (including iSCSI host channel IP settings for an iSCSI system), and update them if
they are incorrect.
271
Info. The storage system could not get a valid serial number from the controller's FRU ID SEEPROM, either
because it couldn't read the FRU ID data, or because the data on it are not valid or have not been
programmed. Therefore, the MAC address is derived by using the controller's serial number from flash. This
event is only logged one time during bootup.
Recommended actions
• No action is required.
272
Info. Expansion of the indicated snap pool has started.
Recommended actions
• No action is required.
273
Info. PHY fault isolation has been enabled or disabled by a user for the indicated enclosure and controller
module.
Recommended actions
• No action is required.
HP P2000 G3 MSA System Event Descriptions Reference Guide 41