Table of Contents
Advertisement
System Features
Remote Maintenance
--- Remote Maintenance
(CPC-S and CPC-M)
Description
The DBS 824 can be programmed from a remote terminal or from a remote
PC by connecting via modems to the Maintenance port on the Serial Interface
Unit (SKJ). The Remote Programming Mode may also be used locally by
directly connecting to the Maintenance Port.
Remote Programming
Mode
(CPC-S and CPC-M)
Remote Programming Mode uses a modem connected to a "dumb" terminal
or a PC terminal program to access a modem connected to the DBS 824
_
Maintenance serial port. Local programming bypasses the modems and
connects directly from the PC or terminal to the Maintenance serial port.
When programming from a terminal connecti. to the RS-232C
(Maintenance) port either directly or via a modem, perform the following
steps:
1. Make certain that any cables and modems are configured and connected
as outlined in Section 300.
2.= ;.Ent.er your terminal communications program and make sure your PC's,
.- :. ,;~~~=~~~.~~~~~~icatiqns settings match those of the DBS824;
_ .,
_.- -..
-.
__ ./.z
.
._
31 'If com&chg r&&ely using modems, dial up the DB-S 824 Maintenance
port modem following the procedures for your terminal package. Once
connected, if the Bus Monitor is active, Bus monitor information may
display.
4. Set the DBS 824 to the terminal communications mode by entering or
have someone on site enter the following code at an extension or
attendant position:
#!Nxxxx (where xxxx = the site's password)
5. After the DBS 824 displays the DBS Remote Programming Banner
Screen,-type
P
and then press Enter.
Issue Date 3/l/95
DBS 824-l O-700
l-31
Advertisement
Chapters
Table of Contents
