Forced Account Codes - Panasonic DBS 824 Installation Manual

Forced Account Codes FF3
Forced Account Codes
Software Version: CPC-S and CPC-M, Version 1 .O and higher
Address: FF3 (ExtPort) 5# (0-2)#
Description
With this programming address, DBS 824 extensions can be programmed so
that the caller has to enter an account code before accessing a trunk for an
outgoing call. This address also enables or disables system verification of the
entered account code on an extension-by-extension basis. This programming
address affects the Toll Restriction Service (TRS) type used for the outgoing
call.
If an extension is set for
Forced Verified Account Codes,
callers on that
extension are restricted from making outside calls without first entering a
valid 4-digit Account Code. After the caller enters the Account Code and the
DBS 824 verifies it, the system will use the TRS type assigned to the Account
Code rather than the TRS type for the extension or trunk.
If the extension is set for
Forced Unverified Account Codes,
a caller can
place outside calls after dialing a valid Account Code (can be l-10 digits
long). The DBS 824 will not verify the Account Code, and will use the TRS
type assigned to the extension to allow or disallow the call.
If the extension is set for
No Forced Account Codes,
callers can place
outside calls without entering an Account Code. However, if a caller wishes
to place a call that would normally be restricted at that extension, the caller
can enter a.valid Verified Account Code to use the TRS type assigned to the
Account Code.
Programming
FF3 (1-16 or l-24)# 5# (0,l or 2)#
I
f
Extension Port-
CPC-S: 1-16
CPC-M: l-24
O=No Forced A'ccount Codes.
l=Forced Verified Account Codes.
2=Forced Unverified Account Codes.
Related Programming
Verified Forced Account Codes: FFl 2# 6# (l-lOO)## l# (0000-9999)#
l- lOO)#
Toll Restriction for Verified Forced Account Codes: FFl 2# 6#/ (
2# (O-7)#
TRS Types Assigned to Trunks or Extensions: FF7 addresses
I
3-8 DBS 824-l O-400
Issued
3/l 195