Support BEL/CAN in ACK/NAK
This protocol responds to <BEL> and <CAN> commands when in ACK/NAK mode. The scanner sounds an error tone
when a <BEL> command is sent from the host. <CAN> terminates the transmission. Default = BEL/CAN Off.
BEL/CAN On
®
Verifone
Ruby Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Verifone Ruby terminal. This bar code sets the baud rate to
1200 bps and the data format to 8 data bits, Mark parity, 1 stop bit and RTS/CTS no timeout. It also adds a line feed (LF) suffix
and programs the following prefixes for each symbology:
Note: If you are having unexpected results with this programming code, scan the
page 1-7 first, then scan the programming code above.
Symbology
Prefix
UPC-A
A
UPC-E
A
EAN-8
FF
EAN-13
F
Verifone Ruby Settings
* BEL/CAN Off
Resetting the Custom Defaults
bar code on
2 - 7