Table of Contents
Advertisement
Troubleshooting
If the video server cannot be
connected
If the language selection window does not
appear when you type the video server's IP
address into the location bar of the web
browser, check the following items.
•
Is the Ethernet cable connected correctly?
If the cable is not connected correctly, the link
indicator at the rear of the video server will not
be illuminated. Check the cable connection.
Note:
Cross-type and straight-type Ethernet cables
are available. To connect the video server
directly to a computer, you need to use a
cross-type cable.
•
Is the link indicator flashing?
If the link indicator is illuminated steadily, it
means that the cable is connected to the video
server but communication is not possible.
The default network settings for the video server
are as follows.
•
IP address: 192.168.0.2
•
Subnet mask: 255.255.255.0
•
Gateway: 192.168.0.1
•
Port number: 80
If you forget the IP Address
If you forget the video server's IP address, you
can check it using the following procedure.
1
Set pin 2 of the communication/terminal
select switch at the rear of the video
server to the "MODEM" setting, turn off
the video server's power, wait three
seconds or more and then turn the power
back on.
2
Set pin 2 of the communication/terminal
select switch at the rear of the video
server to the "PC" setting, turn off the
video server's power, wait three seconds
or more and then turn the power back on.
3
Set the computer's IP address to
"192.168.0. ". (Enter a number that is 3
or greater in place of " ".)
4
Start the web browser and point it to
"http://192.168.0.2/".
5
Check the network settings. (p. 17)
6
Turn off the video server's power.
7
Return the computer's IP address to its
original setting.
Note:
•
If the password for the Administrator level ID has
been changed, be careful not to forget the
password.
•
Check that none of the other devices that are
connected to the network have a duplicate IP
address of "192.168.0.2".
– 48 –
English
Advertisement
Table of Contents
