Changing The Engine Oil - Yamaha 2004 Rhino 660 YXR660FAS Service Manual

CHECKING THE ENGINE OIL LEVEL/

CHANGING THE ENGINE OIL

3 - 14
5. Stop the engine and check the oil level
again.
NOTE:
Wait a few minutes until the oil settles before
checking the oil level.
WARNING
Never remove the dipstick just after high
speed operation because the heated oil
could spurt out. Wait until the oil cools
down before removing the dipstick.
6. Install:
• console
• passenger seat
• driver seat
Refer to "SEATS, ENCLOSURE, HOOD
AND CARGO BED" in chapter 8.
CHANGING THE ENGINE OIL
1. Start the engine and let it warm up for sev-
eral minutes.
2. Stop the engine and place an oil pan under
the engine.
3. Remove:
• driver seat
• passenger seat
• console
Refer to "SEATS, ENCLOSURE, HOOD
AND CARGO BED" in chapter 8.
4. Remove:
• engine oil filler plug (dipstick) 1
• engine oil drain bolt 2
Drain the engine oil from the crankcase.
5. If the oil filter cartridge is also to be
replaced, perform the following procedure.
M MMM M MMM M M MMM M M MMM M
a. Remove the oil filter cartridge 1 with an oil
filter wrench 2.
Oil filter wrench
P/N. YU-38411, 90890-01426
CHK
ADJ
M MMM M M MMM M MMM