Dishwasher Specifications; Technical Features; Enclosure Preparation; Electrical Preparation - Blomberg DWT 14210NBL00 Installation Manual

1 0
( 6
Figure A
2 4 ”
m )
0 m
( 6 1
2 4 ”
( 6 1
0 m
m )
a x
)
a x
” m
m
2 4
m
m
” )
3 0
(

5. DISHWASHER SPECIFICATIONS

5.1 TECHNICAL FEATURES

Load capacity
Permissible water pressure 4.35 - 145 psi (0.3 - 10 bars)
Electrical connection
Total power
Heater power
Because we continually strive to improve our products, we
may change our specifications and design without prior
notice. This device corresponds to the following directives:
UL 749 Household Dishwasher directive.

6. ENCLOSURE PREPARATION

Ý
Notice :
For proper dishwasher operation and appearance ensure
=
that the enclosure has the minimum dimensions shown
in the figure above.

6.1 ELECTRICAL PREPARATION

WARNING
To avoid electrical shock and/or a fire hazard, make
sure electrical work is properly installed. Only qualified
electricians should perform electrical work.
Before installation disconnect the power supply to the
work area by unplugging the unit, "tripping" the circuit
breaker or removing the fuse.
The installer has the responsibility of ensuring that the
dishwasher electrical installation is in compliance with
all national and local electrical codes and ordinances.
The dishwasher is designed for an electrical supply of
120 V, 60 Hz, AC, connected to a dishwasher-dedicated,
properly grounded electrical circuit with a fuse or breaker
rated for 15 amperes.
WARNING
Electrical supply cords must be a minimum #14AWG
copper wire.
Position the cable extending approximately 30" (760 mm)
from the enclosure's back (Figure A).
5
12 place settings
120 V (volts), 12 A (amps), 60 Hz (hertz)
1200 W (watts)
1000 W (watts)