Table of Contents
Advertisement
Installing Options
Removing and replacing the battery
Replace the battery with the same type or with an equivalent type that
!
is recommended by the manufacturer. Dispose of used batteries
according to the manufacturer's instructions.
Caution
5
For information on how to load the BIOS settings, see Chapter 7, Starting
WinBIOS Setup.
5-6
1. Remove power from the chassis and disconnect all power cords.
Remove the CPV5000 from the chassis.
2. Locate the battery on the CPV5000. See Figure on page 3-2.
3. Remove the existing battery by lifting up on the battery's edges and
sliding it out of the holder. Do not try to lift up on the spring clip. The
clip is there to hold the battery in place–it does not function as a release
clip.
4. Insert the new battery into the holder.
Note
Ensure that you insert the battery with the plus sign (+) facing
upwards.
5. Install the CPV5000 in the chassis and connect the power cords.
6. When the CPV5000 powers on, the optimal BIOS setting will have to be
loaded.
Advertisement
Table of Contents
