Front Turn-Signal Lamps - Mitsubishi Electric GRANDIS OXPE10E1 Owner's Manual

Maintenance
3. Turn the bulb socket (F) anticlockwise to re-
move it.
4. Depress the tab (G) on the harness connector
and pull the harness connector to remove the
bulb.
5. To install the bulb, perform the removal
8
steps in reverse.
8-28
CAUTION
l
Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
l Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the
bulb to break the next time the head-
lamps are operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc.,
and refit it after drying it thoroughly.
Position lamps
E01003700279
Have the position lamp bulbs replaced by a
MITSUBISHI MOTORS Authorized Service Point.

Front turn-signal lamps

E01003800690
1. Turn the bulb socket anticlockwise to re-
move it. And remove the bulb from the sock-
et by pulling out.
2. To install the bulb, perform the removal
steps in reverse.
Front fog lamps
E01004001289
1. Remove the 4 clips (A), then pull off the cov-
er (B).