System Maintenance Switch - HP ProLiant DL380 Gen9 Maintenance And Service Manual

Item Description
Optical/SATA port 5
7
SATA port 4
8
Front power/USB 3.0 connector
9
Drive backplane power connector
10
HP Smart Storage Battery connector
11
Optional Location Discovery Services connector
12
Micro SD card slot
13
Dual internal USB 3.0 connector
14
Smart Array/HBA connector
15
Secondary processor (processor 2) PCI riser connector
16
System battery
17
TPM connector
18
Optional serial port connector
19

System maintenance switch

X
System maintenance switch
Position
S1
S2
S3
S4
S5
S6
S7
S8
S9
S10
S11
S12
To access the redundant ROM, set S1, S5, and S6 to on.
When the system maintenance switch position 6 is set to the On position, the system is prepared to erase all
system configuration settings from both CMOS and NVRAM.
CAUTION:
properly configure the server or data loss could occur.
Default Function
Off Off = iLO 4 security is enabled.
On = iLO 4 security is disabled.
Off Off = System configuration can be
changed.
On = System configuration is locked.
Off Reserved
Off Reserved
Off Off = Power-on password is enabled.
On = Power-on password is disabled.
Off Off = No function
On = ROM reads system configuration
as invalid.
Off Off = Set default boot mode to UEFI.
On = Set default boot mode to legacy.
— Reserved
— Reserved
— Reserved
— Reserved
— Reserved
Clearing CMOS and/or NVRAM deletes configuration information. Be sure to
Component identification 111