Canon ImageRunner 2545i Reference Manual page 185

# 0404
Cause
Remedy
# 0406
Cause 1
Remedy
Cause 2
Remedy
6
# 0407
Cause 1
Remedy
Cause 2
Remedy 1 The full path must not be longer than 120 characters. Change or shorten the file
Remedy 2 Change the folder to which the data is saved.
# 0701
Cause
Remedy
6-18
Self-diagnostic Display
The job failed because the write protect switch of the USB memory media
device was on.
Turn off the write protect switch of the USB memory media device.
The job failed because the USB memory media device was pulled out during
transmission.
Check that the USB memory media device is properly inserted, and then try
sending again.
An error occurred while data, such as image data, was being transferred to the
USB memory media device. (The connected device may be formatted with a file
system that is not supported by the machine.)
Check the status of the USB memory media device, or make sure that the
device is formatted with a file system supported by the machine (FAT16 or
FAT32), and then try again.
The length of the full path to the specified file (or folder) exceeded the
supported limit.
The full path must not be longer than 120 characters. Change or shorten the file
name.
The transmission to the USB memory media device was not properly performed
because the length of the full path including the root and file name exceeded the
limit.
name.
The specified Department ID does not exist, or the password has changed.
Enter the correct Department ID and password using
the control panel, and try again. (See "Entering the Department ID and
Password," on p. 2-9.)
- (numeric keys) on