Table of Contents
Advertisement
GEK-36150
Preparing the Printer for Operation
Figure 2-12. Ribbon and Spool Dimensions
1. SLIDE EMPTY SPOOL ON LEFT HUB.
RIBBON OUT SENSOR MUST ENGAGE SLOT.
DO NOT FORCE SPOOL ON . DO NOT
UNWIND TAPE ALREADY ON SPOOL.
RIBBON OUT
SENSOR
RIBBON INSTALLATION
CAUTION:
PRINTER CAN BE DAMAGED BY
INCORRECT INSTALLATION
(
2. ROUTE RIBBON AS SHOWN AND
\11
INSTALL FULL SPOOL.ROTATE ONE
~
SPOOL TO TAKE OUT SLACK . (ONLY
'
ONE SPOOL Will TURN MANUALLY -
DO NOT FORCE)
3. BEFORE OPERATING PRINTER ROTATE BELT BY HAND
IN DIRECTION OF ARROW TO INSURE THAT RIBBON
DOES NOT INTERFERE WITH PRINT FINGERS.----_,
Figure 2-13. Ribbon Installation
PTR-4008
44(902924
PrR-3001
2-7
Advertisement
Table of Contents
