Table of Contents
Advertisement
GEK-36150
Preparing the Printer for Operation
l
PTM-3009
d. Advance the paper with the platen knob.
PIN FEED PAPER ON FORMS TRACTOR (See
Figures 2-5, 2-6, and 2-7)
a. Place the paper supply at the rear of the
TermiNet 300 Printer so that the paper will
feed over the paper pan. If multiple form sets
are used, the shiny side of the carbon paper
must face up as the paper feeds over the paper
pan. Adjust the paper pan for width of paper,
allowing approximately 1/16
11
(1.6 mm)
clearance on each side. The paper guides,
mounted above the bustle, are adjustable to a
maximum paper width of 12 27 /32
11
(32.6
cm).
·
b. Slide the paper behind and underneath the
platen. (When using thick, multiple copy sets,
it may be necessary to push the platen knob
in and manually turn platen to assist the
paper around the platen.)
Figure 2-4. Anti-Curl Device
PAPER TO PAPER
TAKE-UP CONTAINER
PAPER OUT SWITCH
(EMPTY PAPER POS.)
rr /'
l
PAPER OUT SWITCH
(PAPER LOADED POS.)
w---PAPER FROM PAPER
SUPPLY CONTAINER
RUBBER FEET (2) TO
ADJUST PAPER RACK
HEIGHT
PAPER FORWARD
FEED DIRECTION
Figure 2-5. Paper Installation - Pin Feed on Forms Tractor
PTR-4005
2-3
Advertisement
Table of Contents
