Table of Contents
Advertisement
GEK-36150
Preparing the Printer for Operation
SECTION 2
PREPARING THE PRINTER FOR OPERATION
PAPER INSTALLATION
FRICTION FEED (300 PRINTER)
a.
Press the Printer cover release latches and lift
cover (Figure 2-1 ).
I
WARNING
I
POWER IS STILL ON WHEN THE COVER
IS LIFTED. KEEP YOUR HANDS ONLY IN
AREAS
NEEDED
TO
INSTALL THE
PAPER.
b. Remove paper tube (Figure 2-2) from Printer.
c. Place the paper tube in the center of the new
paper roll.
PLATEN
KNOB
d. Set the paper roll and tube in place.
e.
Lift the paper shield (Figure 2-1).
f.
Feed the paper from the bottom of the roll,
over the tension limiter, and under the platen
(Figure 2-3).
NOTE
It may
be
necessary to press the tension
limiter down while routing the paper under
the platen. Make certain the anti-curl device
(Figure 2-4) is positioned in the middle of
the paper width.
g. Push the Platen Knob (Figure 2-1) in and rotate
to advance the paper.
PAPER RELEASE LEVER
in
the
rear (normal) position
PAPER SHIELD
....--RIGHT COVER
RELEASE LATCH
PKM-4008
Figure 2-1. Paper Handling
2-1
Advertisement
Table of Contents
