Medisana CardioCompact 51098 Owner's Manual page 39

5.1 Displaying stored results
This unit features 2 separate memories
with a capacity of 500 memory slots. Results (bloodpressure values
and pulse with date and time and blood pressure indicator) are
automatically stored in the memory. Please follow these steps to
display the stored readings.
1. Adjust the display tilt angle in that way, that the marking of the
tilt mechanism
mode". If this mode is already selected, press a button to
activate the blue background light - only then the stored
readings can be displayed.
2. When the blue blacklight is on, select the user memory
2) first (as described in chapter 3.7 User selection) and press
the MEM-button
3. The amount of results stored in this user memory
shortly (in bottom left display area near by the "M"-symbol).
Then, a flashing "A" and the average value of the measure-
ments taken in the last 7 days in the selected memory is
displayed for systolic and diastolic pressure and pulse.
4. Press the MEM-button
readings (systolic, diastolic, pulse and date/time) including the
blood pressure indicator and arrythmia symbol (if detected) of
the last measurement stored. Press the MEM-button
to move backwards through the stored readings. Together with
the display of the values, the corresponding memory slot
number appears in the bottom left display area. The stored
values are always shown in descending order, e.g. if 7 readings
are stored, firstly no. 7 (the most recent one) is displayed, then
no. 6 and so on.
5. Memory recall mode can be exited at any time by pressing the
START-button
The unit will return to standby mode automatically after approx.
1 minute if no button is pressed.
6. If all 500 memory locations in the memory are occupied, a new
measured value is saved whilst the oldest value is deleted.
3
indicates "Blood pressure measurement
7
afterwards.
7
again to display the individual
6
. The unit is then switching to standby mode.
5 Memory
(user 1 and user 2), each
z
s
GB
(1 or
z
will appear
7
again
35