Table of Contents
Advertisement
PRECAUTION
WARNING: TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR OTHER MOISTURE.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
If the power supply cord (AC power cord) of this
appliance is damaged, it must be replaced. Return to
a SANYO Authorised Service Centre for replacement
of the cord.
Location
For safe operation and satisfactory performance of your
Multiplexer, keep the following in mind when selecting a
place for its installation:
•
Shield it from direct sunlight and keep it away from
sources of intense heat.
•
Avoid dusty or humid places.
•
Avoid places with insufficient ventilation for proper
heat dissipation. Do not block the ventilation holes at
the top and bottom of the Multiplexer. Do not place
the unit on a carpet because this will block the
ventilation holes.
•
Install the Multiplexer in a horizontal position only.
•
Avoid locations subject to strong vibrations.
•
Avoid moving the Multiplexer between cold and hot
locations.
•
Do not place the Multiplexer directly on top of the TV,
as this may cause playback or recording problems.
Avoiding Electrical Shock and Fire
•
Do not handle the power cord with wet hands.
•
Do not pull on the power cord when disconnecting it
from an AC wall outlet. Grasp it by the plug.
•
If any liquid is spilled on the Multiplexer, unplug the
power cord immediately and have the unit inspected
at a factory-authorised service centre.
•
Do not place anything directly on top of this
Multiplexer.
SERVICE
This unit is a precision instruments and if treated with
care, will provide years of satisfactory performance.
However, in the event of a problem, the owner is
advised not to attempt to make repairs or open the
cabinet. Servicing should always be referred to your
dealer or Sanyo Authorized Service Centre.
English
IMPORTANT NOTE (U. K. Only)
The wires in the mains lead are coloured according
to the following code:
Blue:
Brown:
If the colours of the wires in the mains lead of this
apparatus do not correspond with the colour
markings identifying the terminals in your plug,
proceed as follows:
•
The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured blue or black.
•
The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured brown or red.
•
Do not connect either wire to the Earth terminal.
1
Neutral
Live
Advertisement
Table of Contents
