Time Code, User Bits, And Ctl; Time Code; User Bits; Ctl - Panasonic AJ-PG50 Operating Instructions Manual

Time Code, User Bits, and CTL

Time code

The time code is used when the time code signal generated
by the time code generator is to be recorded. The time code
values are indicated on the display and in the superimposed
display.
T R 00:01:04:07
" " is displayed In drop-frame mode, a period is
when there is displayed instead of a colon
no time code signal. between the seconds and frames.

User Bits

"User bits" refers to the 32-bit (8 digits) section of the time
code data that is made available to the user. It allows you to
record operator numbers and other values. The alphanumeric
characters that can be used in the user bits are 0 to 9 and A
to F.

CTL

During playback, the counter displays the playback position
relative to the start position. Recording starts from the
"0:00:00:00" counter value. When recording stops, the counter
shows the current position relative to the start position.
" " : 1st and 3rd fields
" " : 2nd and 4th fields

Setting the Time Code and User Bits

Internal mode
1
Switch to stop mode.
Press the [STOP] button to switch to stop mode.
2
Use the [COUNTER] button to select "TC" or "UB."
3
Set the run mode of the time code generator in the
"RUN MODE" (➝ page 92) menu item.
REC RUN: Advances the time code during recording.
FREE RUN: Advances the time code regardless of op-
erating mode.
4
Set each mode for TC and UB in the "TCG MODE"
(➝ page 92) and "UBG MODE" (➝ page 92) menu
items.
REGEN: Maintains the continuity with the time
code last recorded on a P2 card.
PRESET: Starts recording from the value set with
the [TC PRESET] button.
EXT: Records according to external time code
input.
5
Use the [TC PRESET] button to set the start values
of the time code and user bits.
How to set TC/UB:
1)
Press the [TC PRESET] button.
The left-most digit starts flashing.
2)
Press the up or down cursor button to change the
value.
3)
Press the left or right cursor button to select the
digit to set.
The selected digit starts flashing.
The setting ranges are as follows.
Time code:
User bits:
6
Repeat 2) to 3) of step 5 to change the other value.
Pressing the [RESET] button resets the preset value to 0.
Time Code, User Bits, and CTL:
<59.94 Hz><29.97 Hz>
00:00:00:00 - 23:59:59:29
<50 Hz><25 Hz>
00:00:00:00 - 23:59:59:24
00 00 00 00 - FF FF FF FF
81