Sharp MX-2615N Configuration Manual page 30

StEP 2: ChooSE finiShing Configuration
Configuration D: Advanced 100-sheet Staple Finishing
D This configuration requires the MX-RB12, MX-RB15 and the MX-FN21 or MX-FN22.
• The MX-CF11, both MX-ST10s, MX-GBCX2, MX-FD10, and Plockmatic Production Booklet Maker System are all optional.
• The MX-GBCX2 requires the MX-RB13 (The MX-RB13 is only required when using the MX-GBCX2).
• The MX-RB13 is required to connect a 100-sheet finisher and 2-Tray Inserter Unit directly.
• The MX-FN21 cannot be used with the MX-FN22.
• The MX-BM50 requires the MX-FN21 and MX-PCB50.
• The MX-FD50 must be connected to the MX-TM50.
• The MX-SL10N Status Indicator can be added to any configuration.
and and
MX-RB13 MX-GBCX2
Relay Unit GBC SmartPunch
Pro
TM
Both Units Required
Plockmatic Production Booklet Maker System
Exit Tray Included MX-CF50
with MX-BM50 Cover Feeder
and
MX-FD50 MX-TM50
Square Spine Trimming Unit
Module Module
MX-XB50
Rail Unit (recommended)
© 2013 Sharp Electronics Corporation. All rights reserved.
MX-6500N/7500N C
and/or
MX-ST10
High Capacity
Stacker
and
and
and
MX-PCB50
MX-BM50
Plockmatic
Booklet Maker
Interface Kit
and
and/or and/or
MX-ST10
High Capacity
Stacker
MX-PN13B
3-Hole
Punch Unit
and or
MX-FN21
Finisher 4K
(100-sheet staple)
onfiguration Chart
(continued)
MX-RB15
Curl Correction
Unit
MX-SL10N
Status Indicator
(optional)
D
MX-CF11 MX-6500N/7500N +
MX-RB12 Paper Pass Unit +
2-Tray
MX-RB15 Curl Correction Unit
Inserter Unit
(both required for Configuration D)
MX-TM10
Trimming Unit
and (continued)
MX-FN22 MX-FD10
Saddle Stitch Multi-Folding
Finisher 4K Unit
(100-sheet staple)
MX-RB12
Paper Pass
Unit
30