Connect A Bluetooth Scanner Rs507 Directly To The Vc70 (Scan Profile) - Motorola VC70N0 Product Reference Manual

4 - 26 VC70 Vehicle Computer Product Reference Guide

Connect a Bluetooth Scanner RS507 Directly to the VC70 (Scan Profile)

Once the scanner is connected to the VC70 application in Serial SSI or Wireless SSI (Scan Profile), the
application (DataWedge, Wavelink TE, or any other application using the scanner in this mode) has full
control of the scanner configuration parameters via the application programming interface (API) and can
set or override previously set configuration parameters via the appropriate APIs.
When the application is not running, any scanner can be configured using configuration bar codes, as long
as a scanner-enabled software application (Wavelink, Datawedge, etc.) is not active and the scanner is
connected to VC70. Once an application is launched and the scanner is connected in SSI to the VC70, it is
not able to read any configuration bar codes. To re-enable the ability to scan configuration bar codes, one
must completely exit the application and disconnect and reconnect the scanner to the VC70.
NOTE Refer to the scanner Product Reference Guide for information on configuring the scanner.
NOTE To improve performance use StoneStreet one Bluetooth stack.
Ensure that the scanner battery is fully changed.
1.
Reset the scanner by removing and re-installing the scanner battery.
2.
Scan a Scan Profile bar code to configure the scanner to Bluetooth SPP profile mode before the pairing.
3.
Scan Profile Bar Code
Figure 4-53
Perform a cold boot by removing and re-installing the battery onto the RS507.
4.
To pair the scanner with your VC70, scan the
5.
beeps indicating that it is successfully connected to the VC70. The scanner beeps indicating that it is
successfully connected to the VC70 and Authentication Request box is displayed.
Authentication Request Box
Figure 4-54
Tap to allow pairing.
6. Yes
From the VC70 desktop, tap
7.
On the DataWedge main screen, tap
8.
Tap
9. Advanced Configuration > Profiles > Profile0 > Routes > Route0 > Input > Plugin > Scanner.
bar code in the upper right side of the VC70.The scanner
PAIR
to launch the DataWedge application.
to show .
Running No