Table of Contents
Advertisement
Practical information
F Place the switch in the "O" position.
F Remove the kit.
F drive immediately for approximately
three miles (five kilometres), at reduced
speed (between 15 and 35 mph (20 and
60 km/h)), to plug the puncture.
F Stop to check the repair and the tyre
pressure using the kit.
144
Checking / adjusting tyre pressures
You can also use the compressor, without
injecting sealant, to check and if necessary
adjust the tyre pressures
F Remove the valve cap from the tyre and
place it in a clean area.
F Uncoil the pipe stowed under the
compressor.
F Screw the pipe onto the valve and tighten
firmly.
F Check that the compressor switch is at the
"O" position.
F Uncoil fully the electric cable, stowed under
the compressor.
F Connect compressor's plug to the vehicle's
12 V socket.
F Switch on the ignition.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the C3 and is the answer not in the manual?
Questions and answers
I have a citroen c3 2010 and i open the care with remote from outside and i dont open the dor!!after 30 or 40 seconds he lock agein automatic!!how to fix this problem?thanx
To fix the automatic locking issue on a 2010 Citroën C3 when the door is not opened after using the remote, check the following:
1. Wiring Check – Inspect the wiring between the door and the door pillar for any damage.
2. Remote Key Test – Try using a spare remote key. If the issue occurs only with one key, the lock button on the faulty remote may be stuck.
3. Manual Unlock Test – Use the key in the door lock instead of the remote. If the car does not relock, the issue is likely with the remote key.
4. BSI Reset – Perform a BSI reset, as this can sometimes resolve locking issues.
5. Battery Check – Ensure the car battery and the key fob battery are fully charged.
6. Child Lock Inspection – If the child lock button is illuminated, check if it is affecting the central locking system.
7. Lock/Unlock Cycle – Try locking and unlocking the car manually using the key to reset the system.
If these steps do not resolve the problem, further diagnosis of the locking relays or the BSI may be required.
This answer is automatically generated