Disable / Re-Enable Alarm Devices (B9) - Panasonic EBL128 User Manual

Panasonic Eco Solutions Nordic AB
MEW01624 Rev: -
5.9

Disable / re-enable alarm devices (B9)

Not available for users with access level / type "Information only".
Disabled alarm devices are listed in menu H4/U1.
Outputs for alarm devices can be collectively disabled and re-enabled
via this menu (B9). Disabled output will stay disabled, until re-
enabled again via this menu.
Alarm devices = outputs programmed as type "alarm device" as well
as the COM loop units 3377/4477, 3379, 4380 and 4383.
When all outputs of type Alarm devices have been disabled, also the
LED "Fault / Disablements Alarm devices" (L13) will be turned ON.
When all outputs of type Alarm devices have been re-enabled, the
LED "Fault / Disablements Alarm devices" (L13) will be turned
OFF.
NOTE! This function for alarm devices is not the same as for push
button "Silence alarm devices" (P3) – unless the option Button
"Silence alarm devices" disables alarm devices, is selected in EBLwin
System properties. This menu (B9) has higher priority than the push
button "Silence alarm devices".

Log in with a User name and Password for typ Building officer (or
Service personnel), see page 5.
H1 Perform monthly test
Scroll (or press "2") to menu H2.
H2 Disable or re-enable

Press "A" to sub menu B1.
B1 Disable zone

Scroll (or press "9") to menu B9.
B9 Disable / re-enable alarm devices

Press "A".
Alarm devices in normal condition
or
Alarm devices disabled
will be shown.

Press "A". The condition changes.

Press "Return" (P9) to menu B9.

Scroll to another menu or press "Return" to menu H2. Scroll to
another menu or leave the menu system by pressing "Return".
EBL128 version 2.0.x, Daily user's manual
18