Sanyo DC-F21 Instruction Manual page 4

~oNs
—
.-
~ To an AC outlet
Note:
Do not connect the mains lead to an AC outlet until all connections
have been made.
When the unit is first connected, the display switches automatically to the
demonstration mode. To cancel this mode, turn the power on.
Speakers
Connect the connector of the left speaker lead to the "L" SPEAKERS
socket and the connector of the right speaker lead to the "R" socket.
If you have difficulty inserting the speaker lead connector, turn it over and
reinsert it.
Aerials (For UK)
In areas close to a transmitter the simple indoor aerial is sufficient to
receive broadcasts. Extend the aerial wire as straight as possible and,
while listening to the sound from the system, secure it in a position which
yields minimal distortion and noise.
In fringe areas or where reception is distorted or noisy, an external aerial
AM loop aerial
Assemble the loop aerial as shown in
figure.
Unwind the aerial wires, then connect
them to the AM LOOP ANT. terminals.
@
/
Place the loop aerial in a position which
L
/
yields the best AM (MW/LW) reception, @
~>@ ~~y
or attach it to a wall or other surface as
\
o //
shown in figure.
// /
\\\\ // /
\- /
Note:
To minimize noise, the speaker, mains
and any other leads should not come
close to the indoor or external aerial lead
and AM loop aerial. Do not place the
aerial leads close to the system.
/
Video equipment
Connect audio leads (not supplied) from
\
(not supplied) should be connected instead of the simple indoor aerial.
the audio output sockets of a video
J,-+ ~ ]
Consult your dealer, equipment to the VIDEO IN sockets.
Screws (not supplied)
FM aerial (For AU)
Headphones
The FM indoor aerial is sufficient to receive most local FM broadcasts and
Connect stereo headphones (not supplied) to the PHONES socket for
should be connected to the FM 75 ohm terminal. Extend the aerial wire as
monitoring or for private listening. The speakers are automatically
straight as possible and, while listening to the sound from the system,
disconnected when headphones are connected.
secure it in a position which yields minimal distortion and noise.
In fringe areas or where reception is distorted or noisy, an FM external
aerial (not supplied) should be connected instead of the indoor aerial. The
terminals will accept 75-ohm coaxial cable. Consult your dealer.
3