Removing The Mail Slot - JVC MC-8100U Service Manual

2.1.13 Removing the Mail Slot

1. Open the door. (Refer to 2.1.2.)
2. Remove the side panel L. (Refer to 2.1.7.)
3. Remove the power supply unit. (Refer to 2.1.10.)
4. Remove the #1 magazine. (Refer to 2.1.3.)
5. Insert your hand into the #1 slot and gently push the tray of
the mail slot. Pay attention not to push the tray forcibly for it
could damage the gear teeth.
6. Gently pull out the mail slot tray toward you and push the
guide to the main unit side. Remove a screw
the mail slot panel by sliding it toward the left.
Guide
#
$
7. Remove the six screws
main unit.
#
and pull out
Mail slot panel
to remove the front panel of the
$
$
8. Disconnect the connector cable on the mail CN PCB, and
%
remove the two screws
9. Remove the mail slot from the front of the main unit.
2.1.14 Removing the Top Panel
1. Open the door. (Refer to 2.1.2.)
2. Remove the side panel L. (Refer to 2.1.7.)
3. Remove the side panel R. (Refer to 2.1.8.)
5. Remove the two blind bolts
&
6. Remove the five screws
&
MC-8100U
.
%
Connector cable
^
using a coin, etc.
to remove the top panel.
&
^
2-8