Table of Contents
Advertisement
Drive Units
7-3. Setting the SCSI ID numbers, etc.
s Procedure for the setting the SCSI ID Nos. and other jumpers, please refer to the specified section(s) of the corresponding
drive instruction manuals.
s Make sure to turn the power OFF before starting with the setting procedure. If the procedure is carried out with the power
ON, it will cause malfunction.
s The new ID Nos. will become effective from the moment the power is turned on.
s The new SCSI ID Nos. should not conflict with the ID Nos. of other SCSI equipment on the same SCSI bus.
7-4. Connecting the cables
Please refer to a relevant section of an optional drive unit's instruction manual for
the correct connector positions of the cables.
1.
Connect the control cable (14P).
• Connect the cable with the corresponding number to the drive bay No. If the
cable with the wrong number is connected, it will lead to the equipment mal-
functioning.
2.
Connect the power cable (4P).(The fig-
ure shows the case with the MC-R200U.)
3.
Connect the SCSI cable
7-5. Installing the panels
CAUTION
s Check the installation screws and cables before installing the panel. Insufficient connections may cause malfunctions.
1.
Attach rear and side panels.
• Screw the panels on, following the procedure in "7-1
Removing the panel" on page 21 in the reverse order.
7-6. Automatic drive detection mode
Note:
After installing, adding, exchanging or removing drives, be sure to execute the auto drive detection mode to prevent any malfunction.
1.
While holding key "8" on the control panel, turn on the
MC-8100U.
7-7. Drive type display
The types of the installed drives can be confirmed by the display.
1.
Press the MODE key while the LCD display is in normal display mode
(to display Menu display).
2.
Press the SELECT key 8 times (to display "9. DRIVE DISPLAY").
3.
Press the ENTER key (to select "9. DRIVE DISPLAY").
4.
The type of the drive in each drive bay will be displayed. (Each press of
the SELECT key displays the information on the next drive.)
Meaning of the display
"DVD-RAM" : DVD-RAM drive
"NO DRIVE" : Drive is not connected or installed
● If the automatic drive detection mode has not been executed, the LCD displays "UNKNOWN DRIVE DETECTED".
22
Control cable
1
14p
Drive jumber settings
2
4p
Power cable
3
SCSI cable
2.
Close the door
( a See "5. Door Opening/Closing" on page 17.)
2.
When the LCD display shows "DRIVE DETECTION
COMPLETED", turn off the power of the MC-8100U.
3.
Turn the MC-8100U on again.
"ROM/R etc" :Non DVD-RAM drive (CD-ROM/R, DVD-ROM, etc.)
"UNKNOWN" : When drive detection mode has not been executed.
Internal SCSI cable(approx. 1.2 m)
9 . D R I V E
D I S P L A Y
1 . N O R M A L
D I S P L A Y
D R 1 : D V D – R A M
D R 2 : R O M /
R
e t c
4
Drive No. 4
3
Drive No. 3
2
Drive No. 2
1
Drive No. 1
Changer SCSI
board
Advertisement
Table of Contents
