Table of Contents
Advertisement
3-5. Connecting the power cord and cables
CAUTION
Turn OFF the power of all equipment before starting connections.
Connecting the equipment while power is ON may lead to a malfunction.
Always use the power cord provided by JVC. The library system has been designed to conform to
"Insulation category Class 1". In order to assure safety at all times, be sure to ground the system
WARNING
before use. If other types of power cords other than the specified cord are used, they may overheat and
burn or cause a fire.
Attaching the clamp filters
Attach a clamp filter to the end of the cable.
• The allowable length for the SCSI cable inside the equipment is about 1.2 meters. In the case of SCSI-2 10
Mbytes/sec. sync operation, if the total length of the SCSI cabling including those cables outside the equipment
exceeds 3 meters, a malfunction may result. However, if the SCSI-2 5 Mbytes/sec. async mode is used the total
length of the SCSI cabling should be no more than 6 meters.
• Use a shielded SCSI cable with high-impedance specifications and be sure to attach the provided clamp filter to
the cable. Using other type of cable or using a cable without a clamp filter may cause radio wave interference and
a malfunction.
Tighten until the tabs are
locked completely.
Pull strongly.
To SCSI-A
Attach the provided clamp filters.
To AC IN
Push the clamp filter against the connector
and secure it by using the provided strap.
Cut any
surplus part.
Pull hard
Setup
To SCSI port of
host computer
To AC outlet
13
Advertisement
Table of Contents
