WaterLogic WL3000 Technical Manual
  1. Manuals
  2. Brands
  3. WaterLogic Manuals
  4. Water Dispenser
  5. WL3000
  6. Technical manual

WaterLogic WL3000 Technical Manual

Hide thumbs

Advertisement

Table of Contents

WL3000
Technical Manual
WL3000 Technical Manual - May 2014

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WL3000 and is the answer not in the manual?

Questions and answers

Related Manuals for WaterLogic WL3000

Summary of Contents for WaterLogic WL3000

  • Page 1 WL3000 Technical Manual WL3000 Technical Manual - May 2014...

  • Page 2: Table Of Contents

    UV-C radiation. UV-C radiation may, even in little doses, cause harm to the eyes and skin. Environmental Information 14. Appliances that are obviously damaged must not be used. 15. The replacement of the UV lamp must be carried out by personnel trained by Waterlogic International End of Life or their approved distributors.

  • Page 3: Machine Overview

    COLD AND SPARKLING TANK The WL3000 incorporates a unique and patented split tank to make sparkling water. This technology is part of a double tank system that allows rapid regeneration of carbonated drinks and high volume of cold still water.
  • Page 4 FILTERS WATER VALVES The filtration system on the WL3000 is carried out in three stages. Stage one is Dispensing of water to the customer is achieved by means of a 24V DC electrical the reduction of dirt and sediment particles from the water. Stage two is a Granular solenoid valve.

  • Page 5: Mains Parts Layout

    COLD TANK TANK TANK FAUCET FAUCET FILTER FILTER (Water) DRYER (Water) DRYER COMPRESSOR COMPRESSOR CHECK PUMP FAN MOTOR FAN MOTOR VALVE DRAIN AIR HOLE DRAIN DRAIN VALVES FOR DRAIN VALVE VALVE SOLENOID VALVE 3 WL3000 Technical Manual - May 2014...
  • Page 6 COLD COLD COLD TANK TANK TANK FAUCET FAUCET FILTER (Water) DRYER FILTER (Water) COMPRESSOR DRYER COMPRESSOR CHECK PUMP FAN MOTOR VALVE DRAIN AIR HOLE VALVE FOR DRAIN FAN MOTOR DRAIN SOLENOID VALVE VALVE 2 WL3000 Technical Manual - May 2014...

  • Page 7: Pre Delivery Inspection Procedures (Pdi)

    13. Return both red and green switches to the off position and isolate the power and water to the machine. 14. Drain the hot tank and cold tank. 15. Replace all panels, clean the machine and repack the machine. WL3000 Technical Manual - May 2014...

  • Page 8: Installation Procedures

    Important notice: This procedure should only be carried out by an engineer or 8. Check the electrical socket, if required, and then make the electrical connection staff trained by Waterlogic International or an approved distributing agent. to the machine, by plugging the power lead into the rear of the machine, then NOTE: This appliance is intended for indoor use only and must not be installed in connecting to the electrical socket.
  • Page 9 • The WL3000 should not be connected to water supplies of unknown bacterial REMOVING THE EMPTY BOTTLE quality or those not already fit for human consumption. The WL3000 should only be Turn off the empty bottle and disconnect from gas regulator.

  • Page 10: Operating Instructions

    EXTRA HOT WATER selection Push hot water button. Push extra hot water button. Push dispense button, extra hot water will be dispensed. Note: Default mode for both options is cold water. WL3000 Technical Manual - May 2014...
  • Page 11 Push dispense button, sparkling water will be dispensed. Note: Default mode is cold water Note: Default mode is cold water COLD ONLY COLD 8°C COLD WATER Push dispense button, cold water will be dispensed. Note: Default mode is cold water WL3000 Technical Manual - May 2014...

  • Page 12: Menu Options

    6. To return to the main menu press button ESC. 7. To exit programming press button 4. 7. To exit programming press button ESC. See next pages for Full Menu Options See next pages for Full Menu Options WL3000 Technical Manual - May 2014...
  • Page 13 The UV lamp is set to be on all the time Set at Fahrenheit Set at Centigrade English The display will be in English Language French The display will be in French German The display will be in German WL3000 Technical Manual - May 2014...

  • Page 14: Maintenance And Servicing

    16. Replace the top cover. 4. To remove the Waterlogic filters, twist anti-clockwise and replace with a new 17. Check the air gap around the machine to ensure it is not blocked. Waterlogic twist filter, twist clockwise.

  • Page 15: Descaling A Waterlogic Machine

    5. Bypass the internal twist filter to avoid mixing sanitising solution with the active carbon. Note: To sanitise or descale a machine with a Waterlogic twist filter it is necessary to mix a solution of either descaler or sanitiser in a dummy filter cartridge to flush 6.

  • Page 16: Troubleshooting

    If an anti flood device is fitted to the supply of the Waterlogic has a policy of constant and continual improvement and therefore machine, this should be checked to ensure that it has not activated.

  • Page 17: Environmental Information

    (WEEE) directive (2002/96/EC). The symbol shown above denotes that the product should not be disposed of with general/household waste. Please contact your sup- plier/service agent who will arrange for the collection and disposal of this product. WL3000 Technical Manual - May 2014...

  • Page 18: Biocote

    How Carbonated Water ROHS All Waterlogic machines comply with EC Directive (2002/95/EC) on the Restriction is Created of the Use of Certain Hazardous Substances in Electrical and Electrical Equipment (RoHS). BIOCOTE® ANTI MICROBIAL SOLUTION For your added protection this product incorporates BioCote® antimicrobial tech- nology.

  • Page 19: Electrical Wiring Diagram

    PCB Configuration Motor for compressor Thermistor-cold water Not used Motor for compressor IN UV lamp Pump WLVL Sparkling water level check DANGER HIGH VOLTAGES PRESENT ON THIS PCB CARE MUST BE TAKEN WHEN LIVE TESTING WL3000 Technical Manual - May 2014...
  • Page 20 UV Sensor Hot water heater Thermistor-hot water Motor for compressor Thermistor-cold water Motor for compressor IN UV lamp Power Fuse (250V/10A) DANGER HIGH VOLTAGES PRESENT ON THIS PCB CARE MUST BE TAKEN WHEN LIVE TESTING WL3000 Technical Manual - May 2014...
  • Page 21 Drip Tray Sensor Motor for compressor Internal thermal fuse Motor for compressor IN Thermistor-cold water Power Fuse (250V/10A) UV lamp DANGER HIGH VOLTAGES PRESENT ON THIS PCB CARE MUST BE TAKEN WHEN LIVE TESTING WL3000 Technical Manual - May 2014...
  • Page 22 Internal thermal fuse Motor for compressor IN Thermistor-cold water Pump UV lamp Power Fuse (250V/10A) WLVL Sparkling water level check DANGER HIGH VOLTAGES PRESENT ON THIS PCB CARE MUST BE TAKEN WHEN LIVE TESTING WL3000 Technical Manual - May 2014...
  • Page 23 Motor for compressor Internal thermal fuse Motor for compressor IN Thermistor-cold water Power Fuse (250V/10A) UV lamp Control power switch DANGER HIGH VOLTAGES PRESENT ON THIS PCB CARE MUST BE TAKEN WHEN LIVE TESTING WL3000 Technical Manual - May 2014...
  • Page 24 Faucet (2 hole, including item 18) Faucet (3 Hole) Faucet O-Ring Faucet Nipple Faucet Gauze Silicon tube Hot Sensor Hot Tank 5/16" Drain Valve Level Probe Level Sensor Sleeve 1/4” Straight Adapter Sparking Double Cold Tank *Customer specific WL3000 Technical Manual - May 2014...
  • Page 25 Faucet (H & C) inc Item 13 CT-2007 Faucet O-Ring PL-1013 Faucet Nipple PL-1013-G Faucet Gauze PU-4064 Silicon tube HT-3016 Hot Sensor HT-3017 Hot Tank CT-2031 5/16” Drain Valve CT-2043 Cold Tank PU-4011 1/4” Equal Tee *Customer specific WL3000 Technical Manual - May 2014...
  • Page 26 5/16” Tube 1/4” Drain Valve Quartz Sleeve Sleeve O-Ring SS Insert Faucet Faucet (2 hole) Faucet (2 hole, including Item 12) Faucet O-Ring Faucet Nipple Faucet Gauze Silicon tube Cold Tank Equal Tee *Customer specific WL3000 Technical Manual - May 2014...
  • Page 27 1/4” Equal Tee SS Insert Faucet Faucet (2 hole) Faucet (2 hole, inc Item 18) Faucet O-Ring Faucet Nipple Faucet Gauze Level Probe Level Sensor Sleeve 1/4” Straight Adapter Sparking Double Cold Tank *Customer specific WL3000 Technical Manual - May 2014...
  • Page 28 Solenoid Valve Single 5/16” Tube 1/4” Drain Valve Quartz Sleeve Sleeve O-Ring SS Insert Faucet Faucet (C only) Faucet (C only, inc Item 12) Faucet O-Ring Faucet Nipple Faucet Gauze Silicon tube Cold Tank *Customer specific WL3000 Technical Manual - May 2014...
  • Page 29 Keymat (C & S & H & Ex) Keymat (C & S & A) Keymat (C&S) Keymat (C only) LCD 4 button hole Label 2 button hole label No button hole label Top Cover UV Retain NUT CDS Sensor *Customer specific WL3000 Technical Manual - May 2014...
  • Page 30 Programming PCB Hot Tank with Heater Plastic Cover for PCB Hot Sensor Hot Tank Insulation Cold Sensor Cold Tank (Single) Cold Tank Insulation Compressor Dryer Down Base Rubber Feet Fan Motor Condenser Back Panel WL3000 Technical Manual - May 2014...
  • Page 31 Speak to a Water Expert USA, Canada and Mexico exportsales@waterlogic.com info@waterlogicusa.com + 353 1 293 1960 + 1 402 884 7212 WLI Trading Ltd. Waterlogic USA, 11710 Stonegate Circle Suite 4, 2nd Floor Beacon Court, Omaha, NE 68164 Sandyford, Dublin 18, Ireland www.waterlogic.com...

Table of Contents

Save PDF