Performing Ahardware Reset - Ecobee Smart Thermostat Installation Manual

Auxiliary Heat Run time Alert (optional)
In a heat pump, with auxiliary heat configuration, you can program the
Smart Thermostat to generate an alert if the auxiliary heat runs for more
than this programmed amount of time during a 24 hour period.
Auxiliary Outdoor Temperature Alert (optional)
In a heat pump, with auxiliary heat configuration, you can program the
Smart Thermostat to generate an alert if the auxiliary heat is called for
when the outdoor temperature exceeds this programmed set point (this
feature requires an internet connection to function properly)
List of Alerts
Below is a complete list of alerts. Depending on your configuration,
some of these may not apply to your system.
The battery in your Smart Thermostat will need to
low Battery
be changed soon.
Furnace Air Filter
Your furnace filter needs to be cleaned/changed.
ventilator Filter Your ventilator filter needs to be cleaned/changed.
Humidifier Filter
Your humidifier pad needs to be cleaned/changed.
Comms fault There is no communication between the Smart
Thermostat and the Equipment Interface module.
low Temp. Alert
The temperature in the home is too low.
High Temp Alert
The temperature in the home is too high.
Heat Not
The system has failed to heat the home.
Responding
Cool Not The system has failed to cool the home.
Responding
Input 1
Used if this input is programmed to generate an alert.
Input 2
Used if this input is programmed to generate an alert.
Maintenance
You are due for regular maintenance.
Reminder
Your auxiliary heat source is running too often
Auxiliary Heat
Run Time
Auxiliary Outdoor Your auxiliary heat source is running at higher than
expected outdoor temperatures
Temperature
23
PERFORMING A
HARDWARE RESET
In rare circumstances, static electricity or power surges may inter-
rupt the operation of the Smart Thermostat or Equipment Interface,
forcing a hardware reset.
Resetting the Smart Thermostat
You can reset the Smart Thermostat by pressing the hardware reset
button, located through an opening in the top left corner of the
thermostat, as shown below.
Reset button indicated in solid colour
Pressing the hardware reset button will not alter programming or
configuration options.
Resetting the Equipment Interface
To reset the Equipment Interface, first remove the front cover to
expose the reset switch (see below).
Press the button to reset the relays to their inactive state. They will
turn on AFTER the Smart Thermostat resends the required commands.
This may take up to two minutes.
24
Reset switch indicated above