Samsung 450 series User Manual page 36

Other Information
Purple/green rolling horizontal bars and
buzzing noise from the 1V speakers
with Component cable connection.
Picture is not shown in full screen.
Remote control does not work.
Can not control1V power or volume
with Cable/Sat box remote control.
'Not Supported Mode' message.
Caption on 1V menu is greyed out.
There is a plastic smell from the 1V.
1V Signal Information is unavailable in
the Self Diagnosis Test menu.
1V is tilted to the right or left side.
Channel menu is grey out (unavailable).
Your settings are lost after 30 minutes
or every time the 1V is turned off.
Intermittent loss of audio or video.
You may see small particles if you
look closely at the edge of the bezel
surrounding the 1V screen.
POP (1V's internal banner ad) appears
on the screen.
• Remove the left and right audio connections from the set-top-box. If the buzzing stops, this
indicates that the set-top-box has a grounding issue. Replace the Component video cables
with an HOMI connection.
Black bars on each side will be shown on HO channels when displaying upscaled SO (4:3)
contents.
Black bars on the Top & Bottom will be shown on movies that have aspect ratios different from
your1V.
• Adjust picture size option on your external device or 1V to full screen.
Replace the remote control batteries with correct polarity (+/-).
Clean the transmission window located on the top of the remote.
• Try pointing the remote directly at the 1V from 5-6 feet away.
Program the Cable/Sat remote control to operate the TV. Refer to the Cable/Sat user manual
for SAMSUNG 1V code.
Check the supported resolution of the 1V and adjust the external device's output resolution
accordingly. Refer to resolution settings in this manual.
Caption can not be selected in the 1V menu when connected via HOMI or Component.
• Caption must be activated on the external device.
• This smell is normal and will dissipate over time.
• This function is only available with digital channels with an Antenna (RF/Coax) connection (Air
or Cable). (P. 21)
Remove the stand base from the 1V and reassemble.
Channel menu is only available when the 1V source is selected (Antenna or Cable).
• If 1V is in the Store Demo mode, it will reset audio and picture settings every 30 minutes.
Please change from Store Demo mode to Home Use mode in the Plug & Play procedure.
Press the SOURCE button to select 1V mode, go to MENU ~ Setup ~ Plug & Play ~
ENTER[3l.
Check cable connections and reconnect.
• Can be caused by using overly rigid or thick cables. Make sure the cables are flexible enough
for long term use. If wall mounting, we recommend using cables with 90 degree connectors.
• This is part of the product's design and is not a defect.
• Select Home Use under Plug & Play mode.
For details, refer to Plug & Play (Initial Setup). (P. 7)
~ This TFT LCD panel uses a panel consisting of sub pixels which require sophisticated technology to produce. However,
there may be a few bright or dark pixels on the screen. These pixels will have no impact on the performance of the
product.
36
English