Spare Parts - crystal fires Manhattan User, Installation And Servicing Instructions

23:4
Changing the Gas Control.
Follow Section 23:1 Removing the Burner Mounting Plate Assembly.
If Logs or Driftwood is being used remove and retain the 3 screws securing the Log Support to prevent it becoming
damaged
Remove and retain the 3 screws securing the Air Guide.
With the Burner Mounting Plate Assembly upside down disconnect the Electrode Lead from the Pilot Electrode,
disconnect the Pilot Pipe from the back of the Main Control and the Thermocouple from the Main Gas Control.
Disconnect the Outlet/Injector Pipe and the Main Inlet Pipe.
Remove and retain the 2 screws securing the Main Control.
Fit the new Control and replace all parts in reverse order.
For refitting the Fuel Bed components see relevant section
Check all faults have been corrected then re-commission the fire, conducting the usual safety checks and specifically
gas soundness and spillage tests.
Fit new batteries into the Handset and Receiver
Finally with the Outer Door Closed ensure the Remote Control Handset operates the fire correctly.
part
DOOR GLASS ASSEMBLY
Gas control
handset
receiver
log set
Driftwood set
pebbles
granules
Bark chipping
Ods pilot assembly seagas
Injector 440
ODS pilot assembly SIT
26
Cf1/miami part no
cf1
cf2
cf3
cf4
cf5
cf6
cf7
cf8
cf9
cf10
cf11
CF12
issue 5
Manhattan part no
Man 1
Man 2
Man 3
man4
man5
man6
man7
man8
man9
man10
man11
man12