Before Installation - Sanyo AVC-100 Installation And Operation Manual

CONNECTION (2)
CONNECTING WITH OPTIONAL TV TUNER UNIT
SANYO
TV Tuner unit NVP-TV1000
(optional)
To film aerial x 4
To rear view camera
(optional)
11
AUX3

BEFORE INSTALLATION

t CAUTION
¡When installing the unit, close the monitor and set the ignition key to OFF first.
¡Choose the mounting location where the unit will not interfere with the normal driving function of the driver, and
where not to block access to the hazard switch, an air-conditioning outlet or other important controls.
¡Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and
the unit and the system work properly.
¡Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause
malfunctions.
¡Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
¡Install the unit where it does not get in the driver's way and cannot injure the passenger if there is an emergency
stop.
¡If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance.
¡Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot
air, from the heater, or where it would be subject to dust, dirt or excessive vibration.
■ For proper opening and closing of the monitor, a clearance of at least 170 mm must be
needed between the closest position of the shift lever and the mounting surface for the unit.
Shift lever
* Make sure that there is no obstruction to driving operation.
When installing in Japanese-Made Cars
¡Align the holes in the unit on each side with the vehicle mounting bracket, and secure the
unit with the accessory screws.
MAX3mm(M4) MAX3mm(M4)
T T N
MAX
N T/N
ScrewC (M4)
T: Toyota cars
N: Nissan cars
Separate by
170mm or more
N
MAX
T/N T/N
T
6MAX 6MAX
ScrewA (M5) ScrewB (M5)
for Nissan Cars for Toyota Cars
30°
12