Tuner Section; Main Specifications; Trouble Shooting - Sanyo AVC-100 Installation And Operation Manual

MAIN SPECIFICATIONS

MONITOR SECTION
Display Type Wide LCD color monitor
System TFT active matrix
Size 7 in.
Number of pixel 336,960 pixels
CD
S/N 80 dB
Frequency response 20 Hz – 20 kHz
Total harmonic distortion 0.05% (1 kHz)

TUNER SECTION

Receiving method Double-conversion
super-heterodyne system
Tuning range FM 87.5 – 108.0
AM 531 – 1602
Sensitivity FM 15 dB
AM 32 dB
S/N ratio FM 55 dB
AM 45 dB
Separation FM 25 dB
Harmonic distortion FM 0.3%
AM 0.5%
DVD
Reading format Non-contact optical reading
(using a semiconductor
laser)
Frequency response 20 Hz – 20 kHz
S/N ratio 85 dB or more
Total harmonic distortion 0.2% or less (1 kHz)
Wow and flutter Within or under the
measurement limit
89
I/O TERMINAL
Inputs 24 pin power supply.......................1
AUX ...............................................3
Outputs Front PRE out ................................1
Rear PRE out.................................1
Subwoofer (mono) .........................2
Power antenna relay control lead ..1
Power amplifier control lead ..........1
Rear Monitor OUT .........................1
OTHER
Power source DC 12 V
Dimensions With monitor closed
178 x 50 x 185 mm
(7 1/8 x 2 x 7 3/8 in.)
(W x H x D)
Weight Approx. 2,3 kg (5 lb 1 oz)
* Design and specifications are subject to change without
notice.

TROUBLE SHOOTING (1)

You may think the unit is damaged at the occurrence of the slightest operational error or bad connection.
Before requesting technical assistance, use the items below to check the unit. If abnormal functioning
persists, stop using the unit and contact the store of purchase.
GENERAL
No power
¡The power connection has not been made correctly.
→ Check the connection or check the fuse.
¡The car does not have an ACC position.
→ Press power on the front panel.
Stored stations and correct time are erased.
¡The fuse has blown.
→ Replace a fuse (p.87).
IMAGE
No image
¡The connection has not been made correctly.
→ Check the connection.
¡DIMMER is adjusted to maximum dark
→ Adjust the DIMMER (p.43).
¡The disc is dirty or deteriorated.
→ Check the disc.
¡The unit is installed at an angle of more than 30°.
¡The unit is not installed in a sturdy part of the car.
¡The parking cord is not connected to the parking brake switch cord, or the parking brake is not applied.
No image on the rear monitor
¡The selected source/mode is not connected.
If there is no output, no image will be displayed on the rear monitor.
¡When the front monitor displays the image of the rear view camera, no image is output into the rear monitor.
SOUND
No sound
¡The connection has not been made correctly.
→ Check the connection.
¡Volume is turned down to mininum.
→ Adjust the volume (p.37).
¡Sound was cut off by MUTE button on the remote controller.
→ Press the MUTE again (p.37)
Sound skips
¡The disc is dirty or deteriorated.
→ Check the disc.
¡The unit is installed at an angle of more than 30°.
¡The unit is installed in a sturdy part of the car.
¡The setting for the outputs are not made correctly.
90