To Connect The Parking Brake Connector Cable; Connection - Sanyo AVC-100 Installation And Operation Manual

TO CONNECT THE PARKING BRAKE CONNECTOR CABLE (2)

●Using the self lock connector.
(Example)
Self-lock
connector
Parking
brake lamp
Parking brake connector cable
Insert the cable end into the self-lock connector.
t CAUTION
When you connect the parking brake connector cable, set the parking brake and stop the engine.
Car may move and an accident may result.
Hint
¡The TV/video signals appear only after you park the car and set the parking brake. When the car starts
moving, the TV/ video signals automatically disappear for safety reasons.
¡If the parking brake signal line is too thin, connect the parking brake connector cable to the parking brake
signal line directly without using the self-lock connector.
¡After finish attachment and connection, please check whether brake lamps, back lamps, horn, and blinkers
operate correctly.
9
Parking brake signal line
Put it into the self-lock connector
Parking brake
switch
Close the self-lock
connector securely.

CONNECTION (1)

Digital output
To car antenna
AUX3
To rear view camera
or video device
(sold separately)
To TV tuner unit
(sold separately)
AUX2
To video deck,
game etc.
REAR MONITOR OUT
To rear monitor etc.
Subwoofer out
(MONO)
Black (0.35m)
To ground *1
To battery
(continuos +12V)
Yellow (0.35m)
To ignition Red (0.2m)
(ACC +12V)
Orange/White (0.2m)
To car's illumination
signal
To +12V power
Purple/White (0.5m)
terminal of the back
lamp lead of a car
To AMP REMOTE IN Blue/White (0.2m)
of an optional
MAX. supply current 0.3A
power amplifier
Blue (0.2m)
To the power aerial
control lead *2
MAX. supply current 0.1A
Light Green (0.25m)
To parking switch wire
*1. First connect the black ground lead, then connect the yellow and red power input leads.
*2. Depending on what antenna you are using, connect either to the control terminal of the motor aerial, or to the power
terminal for the booster amplifier of the film-type antenna.
Note:
If there is no accessory position (ignition ACC 12 V red wire), connect to the +12 V power (continuous 12 V
yellow wire) terminal which is energized at all times.
Power supply cable
White
To front left speaker
White/Black
Gray
To front right speaker
Gray/Black
Green
To rear left speaker
Green/Black
Purple
FUSE To rear right speaker
(10A)
Purple/Black
White
To front left RCA output
To front right RCA output
Red
White
To rear left RCA output
To rear right RCA output
Red
10