Miele KWT 6831 SG Operating And Installation Instructions page 43

Display shows
Problem
The alarm symbol
; is lit up, the
three sensors for
the wine zones are
flashing in the
control panel. An
audible alarm is
also sounding.
The alarm symbol
; and the sensor
for one of the
zones is flashing,
and an audible
alarm also sounds.
The Change active
charcoal filter
indicator — lights
up.
A bar is lit
up/flashing in the
temperature
display.
"F1" to "F3" or "S1"
to "S9" appear.
Possible cause
The door alarm has been
triggered.
The temperature in the zone
concerned has risen higher
or fallen lower than the
temperature that has been
set. This could be due to:
– the appliance door being
opened too often,
– a blocked ventilation gap,
– or a lengthy interruption to
the power supply.
This is the reminder to
change the active charcoal
filter.
Only temperatures within
the range the appliance can
display will be shown.
There is a fault.
Problem solving guide
Remedy
^ Close the door. The three
sensors and the alarm
symbol ; will go out and
the audible alarm stops.
^ Rectify the cause of the
alarm. The alarm symbol
; goes out and the
sensor for the zone
concerned lights up
constantly.
The audible alarm stops.
^ Replace the active
charcoal filters in all three
zones and then confirm
the filter change in
settings mode (see "Active
charcoal filter").
^ Call Miele Service.
43