Troubleshooting Guide - Kenwood KDC-MP338 Instruction Manual

Troubleshooting Guide
Some functions of this unit may be disabled by
some settings made on this unit.
o ·
Cannot set up the subwoofer.
• Cannot set up the High Pass Filter.
• Cannot set up the Fader.
• No Audio control effect on AUX.
~
• Preout is not set to subwoofer.
~
"SWPRE" of
<Menu System> (page 12)
• "Subwoofer output" of <Basic Operation> (page 4)
is not set to On.
• The Dual zone system function is enabled.
IS'
<Audio Setup> (page 7)
o
Cannot set up the subwoofer phase.
~
The Low Pass Filter is set to Through.
~
<Audio
Setup> (page 7)
o ·
Cannot select the output destination of the
subsource In the Dual zone.
• Cannot adjust the volume of the rear speakers.
~
The Dual zone function is disabled.
~
<Audio
Setup> (page 7)
o .
Cannot register a security code.
• Cannot set up Display illumination Control.
~
<Demonstration mode Setting> (page 14) is not
turned off.
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
Tuner source
D
Radio reception Is poor.
t/ The car antenna is not extended.
IS'
Pull the antenna out all the way.
--------------------------------
Disc source
D
The specified disc does not play, but another one
plays Instead.
t/ The specified CD is quite dirty.
~ Clean the CD.
';;"fh'e'dlsc'i's"io'ade<frn':3'aWferent'siot from that
specified.
~
Eject the disc magazine and check the number
___ fC?!.~h.~.?.P.~s.~D~sL9~~S:. __._ .
t/
The disc is severely scratched.
~
Try another disc instead.
Audio file source
D
The sound skips when an Audio file is being
played.
t/ The media is scratched or dirty.
Q'
Clean the media, referring to the CD cleaning of
._
~~.~.?.~.c;!!9..~.9.1'.:' .. ~.~.I}.~!l~9..Q~?> (page 3).
t/ The recording condition is bad.
Q'
Record the media again or use another media.
--------------------------------
English
I
21