Installation - Kenwood KDC-MP338 Instruction Manual

Installation
non-Japanese cars Removing the hard rubber frame
Metal mounting strap
(commercially available)
Firewall or metal support
\
Bend the tabs of the
mounting sleeve with a
screwdriver or similar utensil
and attach it in place.
Self-tapping screw
(commercially available)
1
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Upper the frame and pull it forward as shown in
the figure.
Accessory@
Removal tool
2
When the upper level is removed, remove the
lower two locations.
~
~
• The frame can be removed from the bottom side in the
same manner.
~
• Be careful to avoid injury from the catch pins on the
removal tool.
5
Pull the unit all the way out with your hands, being
careful not to drop it.
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Remove the screw (M4
x
8) on the back panel.
3
Insert the two removal tools deeply into the slots
on each side, as shown.
4
Lower the removal tool toward the bottom, and
pullout the unit halfway while pressing towards
the inside.
Screw (M4X8)
(commercially available)
/ Accessory@
&'"
Removing the Unit
ars
ars
, -
+-
T@ @N
@ @
IT/N
N
T
L-.
/1
TToyota c
N: Nissan c
!?
-=r
smm
MAX.
~~8mm
M AX.
H @
I-..
H~
0Smm
05mm
Accessory@...for Nissan car
Accessory@...forToyota car
Screw (M4X8)
(commercially available)
Make sure that the unit is installed securely in place. If the
unit is unstable, it may malfunction (for example, the sound
may skip).
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Align the holes in the unit (two locations on each
side) with the vehicle mounting bracket and secure
the unit with the accessory screws.
~
Japanese cars
~
~
20
I
KDC-X492/KDC-MP438U/KDC-MP408U/KDC-MP338