Program Recording (Cd = Md / Cd = Tape / Twin Rec) - Kenwood HM-382MD Instruction Manual

Program recording
Desired CD tracks can be programmed in the desired sequence and recorded onto an MD or tape.
Be sure to put the MD recorder and cassette deck in stop mode.
1
Make the preparations for recording.
1 MD
: Insert a disc into the MD recorder.
TAPE : Perform steps 1 to 3 of the procedure
in "Recording on TAPE".
2 Insert disc in the CD player.
2
Program the desired sequence of CD
tracks.
Perform steps 1 and 2 of the procedure in
"Listening in the desired sequence (Program
playback)".
3
Start recording.
CD = MD / CD = TAPE
To interrupt a recording
(Recording and playback will be
stopped.)
Note that this cassette deck cannot record onto
Metal tapes.
Note Note
(CD = MD / CD = TAPE / TWIN REC)
º
¤
MD O.T.E.
or
TAPE O.T.E.
STOP
Convenient Recording Methods
÷ When the PGM/AUTO/MONO key is pressed to cancel
the edited contents, the entire editing contents will be
erased.
÷ Tracks programmed beyond the available MD or tape
recording time will be interrupted in the middle.
TWIN REC
1 Select "REC MODE ?" then
"TWIN REC ?".
menu
2 Start recording.
At the end of the recording
MD recorder : Stop.
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec. has
been produced.
Do not turn power off or apply shock or impact while
"WRITING" is displayed. If the power cord is un-
plugged before "WRITING" disappears, the recorded
or edited data will be lost.
43
¤
volume/
multi control
up
down
set/demo